Feeding and conveying of skin sensitive film press
The feeding end of skin sensitive film press adopts automatic identification and centering conveying.
Solve the problem: ensure that the plate is in the middle of the film pressure, and there is no need to add another centering conveying equipment.
Sectional conveying design of membrane press
solve the problem:
In order to avoid excessive waste of UV film, the feed of membrane press and membrane pressure are transported by frequency conversion in sections when seamless plate loading cannot be realized in real production.
The front plate will not continue to press the film until the rear plate is in place, so as to avoid the waste of air compression UV film with too large space between integrated conveying plates. At the same time, the production efficiency remains unchanged, and the feeding interval between plates can be shortened from ordinary ≥ 50cm to ≥ 15cm. Reduce the waiting limit for loading, facilitate manual and flexible loading, and reduce the invalid loss of UV film.
The difference between the three roll coating head and the two roll coating head is that an adjusting roll is added. By adjusting the gap between the adjusting roll and the reclaiming roll, the wet film thickness can be adjusted.
The roller coating machine with high production speed of skin sensitive film press is often equipped with two coating heads. Two coating heads are set on the front of the coil. The purpose of setting two coating heads is to quickly replace the coating and coating roller.
